Peanut Candy Dispenser Nutella Glass

I downloaded and printed another candy dispenser. It was nice and worked fine with small candies, but I wanted a dispenser that could also do chocolate peanuts and created this one.

By changing the rotor, both larger and smaller sweets can be dispensed.

Due to the exchangeable threaded insert, other jars such as pickles could also be used. Unfortunately, I only had Nutella jars at my disposal so far and therefore only made it for these.

If there is a greater demand, I would submit them later.

The threaded insert works with Nutella jars in the sizes 450g, 750g and 1kg

With very large or irregularly shaped sweets, something may block the rotor.

It usually helps to move the screw back and forth or shake the dispenser a little.

Layer height 0.2mm

Infill 20%

Tree support structure is only required for the main body, rotor and hopper

For a secure fixation of the threaded insert, I recommend using at least 6 plugs.

When placing the rotors in the slicer, make sure that the shoulder with the internal thread is at the top, otherwise a support would be printed here that would be difficult to remove and possibly impair the function of the thread.

Before assembly, it is advisable to test the function of the thread and, if necessary, to make the internal thread work with an M8 screw and a little feeling.