DUCK WITH KNIFE MEME

Protect your savings with this knife wielding duck!!!!!

This armed duck piggy bank has good space inside for coins and bills of all denominations, also the model comes in its version with screw cap to be able to extract the contents without breaking it, in its safe piggy bank version where at the end you will have to break it and a scalable solid model so you can also have it as a display figure in any size adapted to your space; the base has with space where you can place the short phrase that you prefer in any 3D modeling program that supports STL or editor as 3D Builder.

NOTE: Inside the files you will find a quick tolerance test of the threaded cap I included, that way you can more confidently print the larger model once you are satisfied with the thread movement mechanics.

WARNING: To place the knife I recommend epoxy glue in its solid version and in the safe piggy bank, the one that includes lid I recommend placing neodymium magnets to adhere this because the same accessory is used by fitting on its back in the opening of the lid to open it.

I HOPE YOU LIKE THE DESIGN!!!!!

Protect your savings with this duck with a knife!!!!!

This armed duck piggy bank has good space inside for coins and bills of all denominations, in addition the model comes in its version with a threaded lid to be able to extract the content without breaking it, in its safe piggy bank version where in the end you will have to break it and a model in scalable solid so that you can also have it as a display figure in any size adapted to your space; The base has a space where you can place the short phrase that you prefer in any 3D modeling program that supports STL or an editor such as 3D Builder.

NOTE: Within the files you will find a quick tolerance test of the threaded cap that I included, that way you can print the larger model more safely once you are satisfied with the mechanics of movement of the thread.

NOTICE: To place the knife I recommend epoxy glue in its solid version and in the safe piggy bank, the one that includes a lid I recommend placing neodymium magnets so that it adheres because the same accessory is used by fitting its rear part into the opening of the lid to open it.

I HOPE YOU LIKE THE DESIGN!!!

Use the parameters of your confidence but in a matter of supports do not forget to place a few more in his arms, the knife can print it inclined about 30 to 35 degrees with its edge up without problem.

Use the parameters you trust, but in a matter of supports, don't forget to place a few more on their arms, you can print the knife tilted about 30 to 35 degrees with its edge facing up without problem.