Adapter from Allen Keys screwdrivers (Adapter from Allen Keys screwdrivers)

English:

Hello everyone. I bring you a permanent adapter to insert allen wrenches and convert them into screwdrivers.

(For now, I only have ready and tested handles for 1.5mm, 2.0mm, 2.5mm, 3mm, 4mm and 5mm wrenches, soon I will have them all).

Steps:

1.

To permanently insert the allen wrenches into the handles, you need to cut the short leg of the wrench at a distance of 10mm as shown in the attached photo.

2.

Depending on the layer height chosen (I suggest 0.2mm) in the laminator program calculate the exact moment where printing can be paused in order to insert the allen key.

3.

Insert the allen key and adhere it with a few drops of cyanoacrylate glue. Wait a few seconds and when the key is firmly adhered, resume printing and wait for the print to finish.

4.

In low relief is the type of key (1.5mm ... etc.). You can use a fine-tipped indelible pen to draw the number and be more legible.

5.

If you want to give it a better finish, you can give it a coat of lacquer or clear varnish.

Enjoy your new tool! :D

Español:

Hello everyone. I bring you a permanent adapter to insert allen keys and turn them into screwdrivers.

(For now, I only have the handles ready and tested for the 1.5mm, 2.0mm, 2.5mm, 3mm, 4mm and 5mm wrenches, soon I will have them all).

Steps:

1.

To permanently insert allen keys into the handles, the short leg of the key needs to be cut to a distance of 10mm as indicated in the attached photo.

2.

Depending on the chosen layer height (I suggest 0.2mm) in the laminator program calculate the exact moment where you can pause the print to be able to insert the allen key.

3.

Insert the allen key and adhere it with a few drops of cyanoacrylate glue. Wait a few seconds and when the key is firmly attached, resume printing and wait for the print to finish.

4.

In low relief is the type of key (1.5mm ... etc.). You can use a fine point indelible marker to draw the number and make it more legible.

5.

If you want to give it a better finish, you can give it a coat of lacquer or clear varnish.

Enjoy your new tool! :D

English:

• Can be printed on any hard filament (PLA, PLA+, PETG, ABS, NYLON, ASA).

-Layer height of 0.2mm

-Nozzle between 0.3mm and 0.4mm.

-In the program it is necessary to see at what point a pause should be added to be able to insert the allen key and then continue printing.

-No brackets are needed.

-Minimum 95% padding to ensure good strength.

English:

• It can be printed on any hard filament (PLA, PLA+, PETG, ABS, NYLON, ASA).

-0.2mm layer height

-Nozzle between 0.3mm and 0.4mm.

-In the program you have to see at what moment you should add a pause to be able to insert the allen key and then continue printing.

-No supports needed.

-Minimum 95% filling to ensure good resistance.