Laptop Stand / Gadget Stand / Accessory Stand

Commercial rights, extensive variations and model advice available on my Petreon if anyone is interested, thank you very much for your support!
https://www.patreon.com/ShapeMaven

Do you want your desk space back?
Do you want your laptop to run cooler while plugged in to a docking station?
Do you want to pack away your laptop neatly while not in use?

This design was originally intended to be used in pairs as laptop stands, although they work well to hold up small-to-medium sized gadgets and accessories too! One stand does hold up a laptop, however, two stands make it much more stable.

These stands have been designed to keep the laptop upright as stable as practical!

Use of a slider in clamping mechanism means moving parts do not come into contact with the laptop/gadget/accessory, no scratches or damage!

I have included 20mm, 25mm, 30mm and 35mm bolts each with clearances of 0.1mm and 0.2mm on the thread (vertical and angled edges) so you can chose the length of bolt depending on the width of your laptop (or gadget or accessory) and the clearance to ensure high quality and functional prints on a range of printers, low end to high end.

I have also included options of the slider that have 0.1mm, 0.2mm, 0.3mm and 0.4mm clearance on the dove tail.

Tried and tested with PLA+ with good results. 0.18mm layer height. 60mm/s base print speed (all on a FF Guider IIs).