SUPER - LONG RANGE WIFI ANTENNA

Long range WIFI Yagi antenna- 3d printed!
Very well calculated, 20dBi Yagi wifi antenna. It shows great results at 2.4GHz-2.5GHz.
Yagi type of antennas are generally very delicate, very powerfull and not so easy to make, but with power of 3D printing, nothing is impossible! :)
See the picutres how it perform on my computer :)
This one has 16 "elements" that are covered in self-adhesive aluminium foil tape. Only for Dipole (look at the pictures) i used copper tape, since its easier to solder than aluminium.
You get everything you need to make your own long range wifi antenna, plus you will get wall mount (not shown in pictures)
Bill of materials also includes little bit of aluminium adhesive tape, little bit of copper tape (about 10cm or 3-4inch will do) and pigtail connector with RP-SMA MALE connector

I splitted the main body in 2 parts, so you can print them diagonally on 200x200mm beds. After printing everything, you will need to glue thoose 2 parts of the main body as flat as possible (i used clamps and when asured that everything lies flat on the table i put some drops of acetone to weld 2 parts together. After that i put couple of drops of super glue, just to make sure). In pictures i show also how i wrapped every element with tape. There are 6 different types of elements, all color-coded on pictures, and in names, so make sure that you follow the pictures. Dont worry, antenna is really easy to print and assemble, once you see the pictures :)