Long control stick for DJI FPV RC

The Stock control sticks that comes with DJI FPV controller is way too short and small for a proper grip and precise input for FPV simulator or real FPV drone flying. I have been struggling to hold them properly since i m used pinch style.
I had searched almost everywhere for a better sticks but some metal sticks available online are way too pricy and mostly out of stock. Searched other 3D design websites but couldn't find one good design that suits my interest.
So designed one in Fusion 360 and that turned out to be good for my flying style.

This is perfect fit just need to use M2X6 screw and no need to glue the screw to the sticks because I designed it to fit just right and stay inside. Just screw them on as you normally do with regular sticks.

0.2mm or finer layer height with 50% infill with cubic subdivision infill pattern,
PLA or ABS of any colour, No supports needed (print vertically with smaller tip bottom on bed). Use glue stick or any other bed adhesion method like white glue mixed with 70% of water and make thin slurry and apply on hot bed with a brush.
Print at 50% of original speed to avoid knocking the model off the bed or use Brim bed adhesion.

If you have any doubts or questions feel free to ask in comments.