Terrarium 15cm x 15cm x 22cm stackable

Terrarium for rearing tree-dwelling tarantulas, mantids or other insects.

No screwing necessary, because the terrarium is completely for plugging together but can of course also be glued with silicone. The terrariums can be easily stacked on top of each other and sit very firmly, so that falling down is not possible.

Terrarium has a double ventilation and thus the air circulates perfectly and a mold thus excluded.

Was used 2.5mm plexiglass.

Dimensions for the plexiglass :

For the bottom : 1x 119mm x 119mm

For the side walls: 2x 106mm x 200mm

For the bottom base: 1x 119mm x 50mm

For the back: 1x 118mm x 200mm

For the trap door: 1x 118mm x 160mm

You can get Plexiglas at any hardware store and it's very easy to cut at home. Cut with the cutter knife to the correct dimension and then break at the edge of the table.

PETG was used as the printing material.

Printer parameters for Cura :

Quality :

 Layer height 0.15mm

Wall:

 Wall thickness 0.8mm


 Number of lines of the wall 2

Top / Bottom:

 Thickness top / bottom 0.8mm


 Thickness top side 0.8mm


 Top layers 6


 Thickness of the bottom 0.8mm


 Lower layers 6

Fill:

 Density of filling 10%.


 Fill pattern grid

Material:

 Pressure temperature 230°


 Printing plate temperature 80°

Speed :

 Print speed 60.0mm/s.

Cooling:

 Fan speed 5%.