"Jake" Angry Birds Feeder

This is Jake, a feeder in the style of Angry Birds.
Case size 158x112x190

The model can be printed in two modes:
- Fast spiral printing, 4 hours! (a nozzle with a diameter of 1mm is required)
- Regular printing, about two days...

The model is made in three mounting options:
- Self-tapping fastening
- Suspended fastening
- Attachment on suction cups
You can buy or view the sizes of suction cups by following the link
Advice! at first, tie up the feeder with a rope, make sure that your suckers hold the feeder securely, then untie the rope)
To complete the product, you will need a Chinese wand, if the wand is too narrow, wrap the tape))

View all models of the collection
- Red
- Chuck
- Jake
- Bomb
- Matilda
- King Pig

Feed the birds and appreciate your time friends!

I hope you will like the works presented,
and I will be very grateful if I see your prints
on this page, which will encourage me to develop new designs. 🤗

Printed on the Creality3D Ender 3 V2 Neo printer,

Print Settings

SPIRALIZE OUTER CONTOUR
Material PLA
Nozzle 1mm!
Layer Height 0.4
Initial Layer Height 0.1
Line Width 1.5
Bottom Layers 8 (3mm) (for hanging attachment, filling the bottom is not required)
Printing Temperature 230°
Build Plate Temperature 70°
Flow 100%
Wall Speed 18
Outer Wall Speed 18
Travel Speed 40
Initial Lauer Speed 10
Number of Slower Lauers 3

Regular printing
No Supports (very important to disable them)
Horizontal expansion = 0 (very important)
Layer Height = tested in 0.1, 0.2 & 0.3 mm
Wall Line Count = 5
Top/Bottom Thickness = 3mm
Infill = 20% appropriate
Print sped = 40 ~ 50
Retract at layer change = ON (recommended)
Z Hop When retracted = ON (recommended)