*** New design ***
The 3D data is suitable for TPU, PLA, ABS, PETG and other materials.
Without screws, metal clips, etc.!
Absolutely unbreakable in the TPU version!
Ideal for the whole family!
Tired of having to constantly change the batteries of my old flashlight, due to the extreme brightness, I built myself one. It had to look nice, be sturdy, very bright, and the battery had to last a long time.
The result is now this flashlight, which I would like to share with you.
With the new ring element, the flashlight can be further customized.
You can use an old existing lithium ion cell. Even with a remaining capacity of maybe 1000 mAh, you can run the flashlight for about 5-6 hours.
With a 3500mAh cell, the lighting time is up to 15 hours, and even up to 40 hours with a two-stage switch.
What makes this flashlight special is the simplicity of its construction. It consists of only 4 printed parts, a standard rocker switch, bright 5mm LEDs and charging electronics available everywhere. No LED driver is needed because when using white LEDs with a minimum required voltage of 2.9V, the LEDs lose brightness relatively late.
From the cell's maximum voltage of 4.2 V to 3.0 V, it lights up with high brightness. Only when the LEDs lose brightness, it is a sign that the flashlight should be charged. However, it can still be used until the LEDs then go out almost completely at 2.5V.
The integrated circuit prevents deep discharge of the built-in cell.
I would be very happy to see the flashlight as a "MAKE".
Have fun with it!
Properties:
Unique in design
Very robust
lies non-slip in the hand
consists of only 4 printed parts
very easy to assemble due to screwed elements
only standard components are used
very cheap, approx. 3 β¬ without battery, approx. 6 β¬ with battery
Approx. 15 to 45 hours of lighting time (depending on battery and luminosity)
7 powerful LEDs connected in parallel (up to 1 watt, or more, depending on LED type).
Is easy to operate
Rechargeable via USB-C port in about 2-3 hours
LED status indicator about charging status (charging / charging finished)
Ready to use at any time for years with charged cell
Deep discharge and overcharge protection
Spare parts can be printed out yourself or purchased at low cost at any time
In the TPU version absolutely unbreakable
Components list:
1x Lithium-ion charging module with protection function and USB-C connector, e.g. USB-C charging module or here
1x Lithium Ion battery, 18650, typ. 3.7 V
1x Rocker switch, e.g. this
1x resistor 3.3 ohms, 0.5 W (for two-stage switch: 2.8 ohms and 9 ohms, 0.5W each)
3x cable, 14 cm, different colors
2x cable, 5 cm, different colors
1x piece of transparent filament (e.g. PETG) as light guide for the LED display (optional).
Optionally, a 2-stage switch can be installed with 2.8 Ohm (2x 5.6 in parallel) and 9 Ohm (2x 18 Ohm in parallel) resistance, for a two-stage LED flashlight. See picture with silver flashlight.
Files:
Body Battery Template.stl -> main body, holds the cell and guides the cables, without logo/symbol
Body Battery Tribal.stl -> main body with tribal symbol
LED Holder.stl -> mounting plate for LEDs
Reflector.stl -> Reflector to be screwed onto the main body
Ring.stl -> Ring as design element
Flash Light Schematic.pdf -> Circuit diagram of the LED flashlight
Flash Light Assembly.pdf -> illustrated assembly instructions, old design, but is equally valid for new design
CAUTION: Do not shine in the eyes!