Finger Spinners Print-in-Place Fidget Toy for Fun ADHD Anxiety Relief

We've made a variety of fidget toys in our days, and this one has gotten the best response by far. These are double rings that spin on your thumb, finger, or fingertip. Just pop it on your finger and spin away. It's so smooth and spins so easily, after a few moments you may not even realize you're doing it.

It actually spins multiple ways. The most satisfying is to put it on your finger and spin it with your thumb. Another option is to hold the outer ring between your thumb and middle finger, then spin the inside ring with your index finger. For two-handed action, you can hold the middle ring and spin the outer ring with your other hand.

It's a print-in-place model, so there's no need for printing multiple parts. The inside ring almost touches the outside ring on the print bed, so if it sticks together, you may have to give it a POP to loosen it up. when they do stick, my husband puts the center ring over the corner of our wooden table and pops it with his palm - works like a charm!

DIMENSIONS - 3 SIZES TO FIT ALL
Our Finger Spinners come in three sizes - Small, Medium, and Large. the Small size is best for kids and also fits most women's fingertips. The Medium size is a bit bigger, and slips on the thumb or down to the bottom of the finger on most women, while fitting well on most men's fingertips. The large size is mostly for men with big hands who want to spin it on their thumb. If you find none of them fit the way you want, take the nearest fit and adjust the scale as needed.

At 100% scale, each size Finger Spinner measures:

Large (Best for Men's Thumbs)
X = 5.8cm / 2.3in
Y = 5.8cm / 2.3in
Z = 2.3cm / 0.9in

Medium (Best for Men's Fingers or Women's Thumbs)
X = 4.7cm / 1.8in
Y = x4.7cm / 1.8in
Z = 2.2cm / 0.86in

Small (Best For Kids Hands and Women's Fingers)
X = 3.7cm / 1.5in
Y = 3.7cm / 1.5in
Z = 1.7cm / 0.6in

Enjoy!

If you like the Finger Spinners for Fidgety Hands, please check out our ever-growing portfolio of STL models (including many more fidget toys!)

• https://www.cults3d.com/en/users/GetPrinted3D/creations

IMPORTANT Copyright Info: Unless otherwise noted, ALL GetPrinted3D designs are Copyright protected. When you purchase a file, you do NOT have the right to sell the file or printed model. Files may not be redistributed under any circumstances. The models are for personal and private use, and may not be sold commercially without the explicit written consent of GetPrinted3D.

You can obtain a Commercial License to legally sell our designs here:
- https://www.patreon.com/GetPrinted3D

Layer Quality: 0.12
Infill: 20%
Speed: 60mm/s
Supports: No
Plate Adhesion: None

The approximate print time is 1 hour for small, 1.5 hours for medium, and 2 hours for large.