Plant pot for professional grower 120 x 120 x 140

Elevator pot for plants. With this model, the focus was on a fast growth of the plants. After about 2 years of fiddling around and trying out, I finally came up with this solution. The test phase now lasts about good half a year, and I am thrilled with the growth of the plants compared to normal pots.

Considered:

1. water management

2. root growth

3. arrangement of multiple pots

4. potting out the plants without damage.

5. labeling option

6. use automatic watering, aeration.

When watering, the excess water drips from the holes and is collected by the coaster. The slopes on the outside of the coaster direct the water to the center of the coaster. The wadding soaks up excess water, storing it. I use aquarium absorbent cotton (about 2g/pot). Later, when the soil dries, the stored water is made available to the plant again. This extends the watering intervals, the water is used optimally.

The roots grow through the holes in the soil and on the side walls. If the roots encounter air/light, they may burn. If not, please cut them back. Both will stimulate overall root growth. This method prevents circle growth, as well as root balling in certain areas (such as the bottom of the pot).

Plant lamps: the square shape allows you, for example, to line up as many pots as you want with maximum use of the area. This is not the case with sloping pots or round pots. Furthermore, the pots are suitable for attaching automatic irrigation and / or ventilation.

Damage-free potting out / repotting of the plants. Simply take pot apart. Fixing plugs out, dismantle the side walls, remove the bottom - done !!!

Labeling possibility by magnetic plaque. Magnets in side panel and plaque provide adhesion. Magnet size: diameter 5 mm, height 1.5 mm. There are breaks in the 3.mf files for inserting the magnets.

.stl/.3mf files:

• Coaster (pot_small_US_v1)

• Side panel without magnets (pot_small_SW_v1)

• Side wall with magnets (pot_small_SW_v3_magnets)

• Bottom (pot_small_BD_v1)

• Fixing plug (pot_small_BS_v3)

• Name plate without inscription

(pot_NS_without_inscription_v1_magnets)

Upon request, I will send you the nameplate files with desired inscription.

0.2 Quality for nameplate

0.3 Draft for rest

25% Infill

Supports only on pressure board