Skymines organizers, part 2

3 organizers designed to manage Outpost markers. In part 1 are available 2 types of Outpost trays. Here are 2 Outpost trays organizers + Outpost reserve organizer.
Using Outpost trays facilitate keeping outpost markers in order during the game. Organizers for these trays and markers help with storage.

1. 2 OUTPOST TRAY ORGANIZERS: There are 2 outpost tray organizers. The bigger one can accommodate 4 Outpost trays filled with wooden company markers (or 8 empty Outpost trays). 2 of such big organizers wouldn't fit the game box, so I've designed a smaller organizer. There can be kept 4 empty Outpost trays (2 piles with 2 trays). In the bigger organizer you can keep 4 Outpost trays fully prepared for the game set up.
2. OUTPOST RESERVE ORGANIZER: If you keep Outposts in the Big Outpost tray organizer, there are some company markers left. The Outpost reserve organizer is designed for these components. You can decide to keep them just in some bags, but this container fit the box nicely beside other organizers, so why not to have it too.

I have designed a whole set of organizers for Skymine board game. You can check part 1 and part3 or the full set.
All organizers fit the game box and provide quick game setup. However it's not an insert. Sliding lids prevent components from falling out during the storage. Rounded bottoms facilitate item draw. Sloped bottoms and indentations facilitate card draw. Theme reliefs and cutouts decorate containers.

Some photos of the full set in higher resolution:
The full set, organizers open
The full set, organizers closed
The full set standing up
Player's component organizers
Outpost trays and Outpost reserve organizer
All outpost trays and organizers
Card trays
Company track container
Packed
Half unpacked
Almost unpacked
The game set up for 4 players
Outpost organizer on the board game and the Research plan organizer near by

All organizers were 3Dprinted on Prusa MK3:
- in PLA (F3D Blue pearl),
- No support is needed,
- Infill 10% rectilinear.
Note1: I use slightly changed default Print settings "0.15mm SPEED MK3" in PrusaSlicer.
Note2: Monotonic top fill increases quality of lids.
Note4: The biggest is Outpost.Container. Its dimensions are: 171 x 190 mm.
Note6: Sliding lids and guides for them in containers are adjusted for 0.15 mm layer height.

Printing Time (for one organizer of each kind):
9. 2 Outpost tray organizers:
7h6' - Big, container
4h16' - Big, lid
4h30' - Small, container
2h38' - small, lid
10. Outpost reserve organizer:
3h54' - container
1h57' - lid