Precision Screwdriver

We have designed a precision screwdriver, it is 100% functional and has enough strength to tighten screws. We have also designed a case so you can take it anywhere and a stand so you can leave it on your desk.

You will need 9 4X4mm magnets, here is a link, but you can look for any that are the same size:

https://es.aliexpress.com/item/1005003970379796.html?spm=a2g0o.order_list.order_list_main.118.21ef194dAHsrzL&gatewayAdapt=glo2esp

You have a version of the screwdriver without bearing and another with bearing, if you want to print the version with bearing, the bearing we have used is the: MR105ZZ 5x10x4mm. I leave you a purchase link:

https://es.aliexpress.com/item/32839200757.html?spm=a2g0o.order_list.order_list_main.53.21ef194dAHsrzL&gatewayAdapt=glo2esp

All designs for each of the pieces to fit together, have an offset of 0.30mm between them, so if your printer is well calibrated, all parts should fit well including the tips and magnets you use. Note also that although this is intended for the standard size of screw tips, but you may have a little thicker because the manufacturer has not made them correctly, if so, you can fit the tip into the hole even if it is difficult to enter and then give heat to the tip itself to widen the gap a little so you can use them, or use the expansion option.

horizontal from your laminator.

Screwdriver with and without bearing:

• Layer height: 0.2mm

• Wall thickness: 0.4mm (i.e. 1 wall line)

• Filling: 100%

• Supports: none

Base:

• Layer height: 0.2mm

• Wall thickness: 1.2mm (or in other words, 3 wall lines)

• Filling: 15%.

• Supports: none

Case:

• Layer height: 0.2mm

• Wall thickness: 1.2mm (or in other words, 3 wall lines)

• Filling: 15%.

• Brackets: none, or only at hinge ends.

Printing must be stopped to insert the case magnets.

We are at your disposal if you have any questions:

https://www.instagram.com/filaworks/

filaworksespana@gmail.com