Bolt stopper for ARTEMIS -> Magazine for Alligator...

Hello here is my bolt stopper for the ARTEMIS -> Magazine for Alligator 2 || 6,5" arrows || Repetierarmbrust by schnuffischulz: https://cults3d.com/en/3d-model/tool/version-2-alligator-2-repeating-crossbow-3d-printed-magazine-inspired-by-joerg-sprave

My new version of a bolt stopper, optimized for different bolt lengths.

Due to the funnel Top and in the middle and no funnel Bottom, the bolts Top and in the middle can have slipped further forward and land Bottom still Rear on the edge with their cams.

The first version had my magazine shredded after about 500 bolts.

The problem was because bolts could skew at the top and had passed that skew on to the bottom.

I had checked this several times, but the bolts always ended up straight at the bottom, except once where I had not checked the bolt was probably skewed and hit the magazine.

You have to scale the stopper in doubt for your bolts, this design is for the extra heavy Bodkin Carbon bolts with the Alunocks from SundK ( https://www.s-und-k.com/product-page/Bodkinbolzen-160mm-schwer ), these are a bit shorter than the other bolts, hence the photos, the distance from the shortest bolts so it must be approx.

The bolts must always fall straight down and at the same time have a few millimeters of tolerance down, because the bolt goes with the tip up when cocking and goes down at the end of the cocking process, so he seesaws and therefore needs play about 2-3 mm. otherwise he can cant and shreds the magazine.

The great thing is, you can simply 3d print it and glue it into the existing magazine with superglue, so you don't have to completely reprint. Important to leave about 2-3 mm space below so that the bolts still fit through under the magazine, that you have to estimate. Too much space will cause the bolt to slide forward more. Too little space, then it shreds your magazine!

I used 20 lines Brim so that you can print well on edge, holds bomb on the board and was easy to pull off by hand.

Resolution: 0.2 mm - 0.25 mm

Infill: 100 %