Sentinel Bot from Transformers G1 Episode Search for Alpha Trion 3D print model

Rolling in from an old G1 episode, here's one of Shockwave's cute little Sentinel Bot whom he sends out for errands :P

Being tasked to help Shockwave around Cybertron, he would probably need to be quite agile and hence four wheels help him roll around. Articulation wise, he swivels at the waist, and have his arms and fingers individually poseable.

Coming to his twin head canons, these are sized to allow for effect parts to be used, as are each of his four finger tips. Pew pew pew!

Flipping around to his back, here's what it looks like with some additional (not-in-the-show) detailing having been added. And again, have taken the chance to plop a pair of 5mm ports for effect parts here, for additional woooooshy goodness!

5mm ports have also be designed into the sides of this waist, so additional parts and weapons can be pegged here too!

=== Assembly ===

The attached diagram shows the parts for Sentinel Bot and how they go together.

This should be fairly easy to print and put together. Just a slight note - some of the smaller parts can benefit from being printed with more walls/infill and lower layer heights to help give them a little more strength.

===

Hope everyone enjoys beaming this little dude over to whereever you are via the 3d printer space bridge!

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog