AirBrush Desk Stand and Wall Support 3D print model

A Useful Desk stand to keep the Airbrush while you clean it or to rest on some place after work...Angle-leveled so you can leave it there even if the cup is full of paint ..you have a narrow lane where let temporary the needle as you clean the rest of the airbush..same at the bottom of the model to let the Nozzle and Needle caps temporarily as you clean each piece of the airbrush...and to save the Needles,Nozzles and needles caps container and the Nozzle wrench to have it located and at hand......as a gift i added a Wall support to screw to wall or table so you can free the working table of that Desk Stand for the same price....Once filled with plaster or concrete it will weight +/- 350 Gr. ( 0,12 Oz.) heavyweight enough to hold any Airbrush model even with the cup filled of paint when you need on some process ( Eg. Masking or unmasking) or any disaster that need your inmediate attention..... There are eight 3D formats to play with .......plus the CTB files for both models ( Desk Stand and Wall support) ,models are decimated to avoid heavy files except in the ZTL file that are the original 6 million poligon quads. Cause is a bit risky 3D print something that size i made two half pieces of the main body and a full body if you want to try at your own risk,and a Ground cap to close the model at the bottom or let open if you like...3d Print files are for a Phrozen Sonic Mini 4K with Anycubic Basic Resin or Sunlu Clear... Size for the Desk Stand is : 80,2 x 81,6 x 58,9 mm ( 3,1 x 3,2 x 2,3 Inch) And for the Wall Support : 67,4 x 49,2 x 31,2 mm ( 2,6 x 1,9 x 1,2 Inch.)