tapestry/flag hanger/clamp wall-mounted

• Prints in 3 parts, the only other required thing is some tape, either double or single sided.

• simply attach to the wall using tape, insert whatever you want to hang from it in between the discs and tighten the nut until it's secure.

• Could be used to clamp several flag/tapestry corners using a single clamp. Don't overdo it, it only needs to be secure, if you overtighten the threaded part of the bottom piece will likely snap off.

• The clearance in between the nut/thread is 0.2 mm!

If you need/want an adjustment or additional version to make it applicable in a broader context or at all please let me know and I will make it and add it to this design.

• For single sided tape use the bottom tape version, this has some extra things sticking out so you can tape over that to secure it to the wall.

• For double sided tape just attach it to the bottom, 3 equally angled strips originating from the middle should be the strongest way to use it (or at least the most efficient use of your tape).

all prints shown in the pictures are done with the following settings:
material: PLA
layer height: 0.28 mm
nozzle diameter: 0.4 mm
infill density: 15% (make sure there is infill in the thread on the bottom disc)
infill pattern: honeycomb (hexagons (bestagons))