SUZUKI HANDLEBAR ADJUSTMENT SV 650 X CLUTCH/CLUTCH

This is an OEM based part but modified to be able to adjust the angle of the clutch lever of the suzuki SV 650 X.

With the original part of the bike you can not freely modify the position of the clutch of the bike because the support of the lever hits against the pinion (left) of controls. At the same time, this lever cannot be rotated as the OEM part blocks the rotation. The part has been redesigned with 3 different positions from higher to lower angle to customize the position to your liking.

Included are designs with 3 positions (1- 24º, 2- 20º, 3- 16º) plus one design exactly the same as the original and another without the bolt that blocks the rotation. **The use of No. 2 is recommended, as it is the average level that will allow the most common adjustment.

This is an OEM based part that has been modified that has been modified to be able to adjust the clutch lever angle of the suzuki SV 650 X.

With the original part of the bike, it is not possible to freely change the clutch position of the bike, as the lever bracket hits the (left) control knob. At the same time, this lever cannot be rotated as the OEM part blocks the rotation. The part has been redesigned with 3 different positions from larger to smaller angle to customize the position to your own preferences.

Designs with 3 positions (1- 24º, 2- 20º, 3- 16º) are included as well as a design exactly the same as the original and another one without the bolt that blocks the rotation. **The use of No. 2 is recommended, as this is the average level that will allow the most common adjustment.

Nozzle: 0.4

Layer height: 0.2

Filling: 100%

Supports: Yes

Print speed: 40-50 mm/s

*It is recommended to configure 5 or more wall layers.

Nozzle: 0.4

Layer height: 0.2

Infill: 100%

Supports: Yes

Print speed: 40-50 mm/s

It is recommended to configure 5 or more wall layers.