Ergonomic 4mm bit holder for 40 bits | Wowstick holder | magnetic | automatic centering | charging also possible with bit

Ergonomic magnetic bit holder for 40 pcs 4mm bits and holder for wowstick and bit quiver and/or other tool.

Magnetic base with very strong hold on flat magnetic surfaces (e.g. sheet steel), additional magnetic small parts container for screws or similar.

A wowstick can be easily inserted with bit up or down, even with bit inserted. The holder automatically centers the screwdriver.

This means that the Wowstick can also be charged in the holder and is still ready to hand and ready for use at all times.

**Notes.

The holder can of course be used without magnets.

The holders for Wowstick, Wowstick bit quiver or similar tools are deliberately kept narrow (16.3mm).

Fits my printer pretty much exactly for an optimal hold of a Wowstick, however sometimes the Wowstick bit quiver can be a bit larger or the printer settings make the holes minimally smaller.

In this case, simply rework with some sandpaper or a rotary sander until it fits perfectly.

To make the bit holder magnetic 4 pieces of round neodymium magnets with 10mm diameter and 5mm height are needed.

For the small parts container, 3 pieces of round neodymium magnets with 8mm diameter and 3mm height are needed.

A soldering iron, set to the melting temperature of the filament used, is best for pressing in the magnets.

If desired, I am also happy to provide a version for gluing in the magnets with larger openings, please just send a quick message.

No special settings necessary. Support is only recommended for the magnetic holders in the lower area.