HEADPHONE STAND WITH PHONE STAND - MODEL 14 - STRUCTURED SURFACE VERSION

Combined headphone stand and phone stand. This version has a structured surface, inspired by carbon fiber.

Size is about 217mm x 144 mm x 228 mm, so make sure it fits your printer and the size of your headphones!
Phone stand is about 90 mm wide and 135 mm in length.

Size of the printed model in the pictures is slightly scaled down, because it did not fit my Prusa MK3s+ (about 20mm lower in height). So the Bose put on the original sized model would have more ground clearance (see the renderings).

Size can be scaled of course, depending on your printer and the size of your headphones.

Bottom surface is flat so it can be put on the printer. I recommend attaching 4 small rubber feet on the printed model for better standing.

Post your print if you like! :-)

Headphones in the renderings are just for illustration and are not included!

By downloading my 3d models you have no right to sell any digital files or printed models of my designs. Personal use only.

Supports are needed. Organic supports work best (see the last picture). Prints best with PLA or PETG. 0.15 mm layer height looks best, at least 4 perimeters or more recommended. Use some infill (around 25% or more) for better stability. I recommend concentrical top layer for better looking base, because the angle is quite shallow and layer lines will be very visible.
Z-Lift should be increased due to slight warping on shallow angles, depending on your filament and temperature settings.