CROCS RUBBER DUCK

Stepping in style! 🌟Give your Crocs a playful twist with this new rubber duck-shaped accessory 🦆

Material: It is recommended to use a strong and durable material, such as PLA, ABS or PETG, to ensure the stability and longevity of your product.

Layer Height: A layer height value of around 0.2-0.3 mm is suitable to achieve a good balance between printing speed and finishing quality.

Filling: 20-30% filling will be enough to maintain the robustness of the internal structure while saving material.

Print speed: The recommended print speed can be in the range of 40-60 mm/s. However, please note that specific values ​​may vary depending on your 3D printer.

Extrusion temperature: The extrusion temperature will depend on the material you choose. For example, for PLA, you can set an extrusion temperature of approximately 200-220°C.

Hot Bed Temperature: If you are using PLA, a bed temperature of 50-60°C should be sufficient. For other materials such as ABS, you may need to increase the temperature of the heated bed.

Supports: it is recomended to print with supports.

Post-processing: Once printing is complete, you may want to sand and polish the surfaces for a smooth, professional finish.

Remember that these values ​​are general suggestions and may require specific adjustments depending on your 3D printer and printing conditions. It is always advisable to make a few test prints before printing the final product to ensure you get the best results.