Monster Acrylic Dice Tube - Conversion

Prints (0)

Description

Summary Convert new or broken Monster Acrylic tubes into Dice Holders and/or Dice Tower; We have several of these tubes from Monster - used to hold playmats; a few seem to chip or crack on the closed ends after being dropped or shoved precariously into a bookbag... instead of throwing them out, we converted a few to hold dice and use them as dice tubes/towers using these inserts. Depending on wear/tear you will need to saw off the closed end or use a hole saw drill bit to cut out a feeder hole to drop your dice in; or fall out depending on your preference. I'll probably rework this for standard circular acrylic tubes (2" diameter) note: I've had to modify the percentage scale a little depending on whether I printed them using an Afinia or a Rep2x; ymmv I printed the two (alternating) single units at 0.30mm height taking about ~90 minutes to print... no support needed; printed 6 and slid them gently into the tube; no glue needed, friction held. I have not printed the alternating units with the mana symbols within them yet; that's lined up for this weekend. The tube rings are used to slide over the acrylic tube as 'grips'; careful not to snap them when sliding over the outside. Fee free to tinker here: https://www.tinkercad.com/things/eyfz5slycTL-monster-acrylic-playmat-tube-dice-tower-single https://www.tinkercad.com/things/ercbcvyK9xF-monster-acrylic-playmat-tube-dice-tower

Design Files

File Size

monster_acrylic_playmat_tube_-_dice_tower.stl
2.44 MB
monster_acrylic_playmat_tube__-end_cap_dice_holder.stl
77.5 KB
monster_acrylic_playmat_tube_-_ring_1_.stl
171 KB
monster_acrylic_playmat_tube_-_faceplate.stl
13.8 KB
monster_acrylic_playmat_tube_-_dice_tower_single_units.stl
106 KB
monster_acrylic_playmat_tube_cap.stl
27.9 KB

Comments

Your browser is out-of-date!

Update your browser to view this website correctly. Update my browser now

×