Coupelle anti-moustique pour pot de fleur/Anti-mosquito cup for flower pot (diameter 111 to 130 mm).

To prevent the proliferation of mosquitoes around flowerpots, remove stagnant water from the bottom of flowerpots every day (especially for tiger mosquitoes).

Here's a new solution, a cup with a grid and an adjustable seal to prevent mosquitoes from laying eggs in stagnant water.

The flowerpot is surrounded, excess water goes into the cup, but mosquitoes can't reach it thanks to the grid and gasket.

The fine mesh takes into account WHO (World Health Organization) recommendations on the size of holes in a mosquito net to block the passage of mosquitoes.

Measure the outside diameter of your pots about 3 cm above the bottom to find the right size.

there are 5 cup sizes, each covering a different diameter range.

Easy, support-free printing, suitable for printers with 220x220 trays.

To avoid the proliferation of mosquitoes around flower pots, you must remove stagnant water at the bottom of the cup every day (especially for tiger mosquitoes)

Here is a new solution, a cup with a grid and an adjustable seal to prevent mosquitoes from laying eggs in stagnant water.

The flower pot is surrounded, the excess water goes into the cup but the mosquitoes can no longer reach it thanks to the grid and the seal

Measure the outer diameter of your pots approximately 3 cm above the bottom to find the suitable size.

There are 5 cup sizes each covering a different diameter range.

Easy printing, without support and suitable for printers with 220x220 tray

Autres Tailles / Other Sizes:

diameter 60 to 75 mm : https://cults3d.com/fr/cr%C3%A9ations/coupelle-anti-moustiques-pour-pot-de-fleur-anti-mosquito-cup-for-flower-pot-dia-houbacan

diameter 76 to 90 mm : https://cults3d.com/fr/cr%C3%A9ations/coupelle-anti-moustiques-pour-pot-de-fleur-anti-mosquito-cup-for-flower-pot-dia-houbacan-2

diameter 91 to 110 mm : https://cults3d.com/fr/cr%C3%A9ations/coupelle-anti-moustique-pour-pot-de-fleur-anti-mosquito-cup-for-flower-pot-di

diameter 131 to 160 mm : https://cults3d.com/fr/cr%C3%A9ations/coupelle-anti-moustiques-pour-pot-de-fleur-anti-mosquito-cup-for-flower-pot-dia-houbacan-3

PLA

hauteur Couche / Layer Height: 0.20mm

Paroi / Wall Thchness: >= 1.2 mm

Infill Dentisity: 100%

No support

For printers with Bowden, we recommend removing the shrinkage when printing the grid.