Wriothesley Pants Accessories

The set of the pants accessories for Wriothesley character from the Genshin Impact videogame.

Contains:
- Back decoration
- Back 'arrows'
- Side 'arrow'
- Front buttons
- Leg belt rings

Back and side 'arrows' provided in two variants: as separate details for ones confident in their skills, and 'merged' for ones not that confident. The former will give better visual impression while the latter is easier in use since one only need to position the single piece.

Belt rings also provided in two variants: with sharp and smooth joins. What to choose is up to your preference. However, it is strongly advised to either ensure there is not too much load put on them, or increase wall count and infill percent when printing, for additional strength.

Front buttons are relatively small so I suggest you use resin printer to print them - this will save you time post-processing them as sanding parts less than 2cm in both width and height can be challenging.

Each part features a 1 mm thick base for improved strength. In case you find this excessive, simply drop each of them 1 mm below build plate. However it is not advised to do so for 'merged' variant of back and side 'arrows' as connecting plate is exactly 1 mm thick.

Note that back and side 'arrows' are of same design but of different size: one at the side is a slightly smaller.

P.S. Keep in mind Wriothesley uses the 'tall male' model, which is said to be 180 cm tall. All of the parts were modelled off that height. If your height differs 10 cm or more from that, then you probably will need to scale parts up or down.