Wing Upgrade for Transformers Legacy Nova Prime 3D print model

Since the wings on Nova Prime was a little bit on the short and stumpy side, here's an upgrade set to extend them and also bring them more in line with how they looked like in the game!

These peg onto the 5mm port on the back of the existing wing and also have a square peg to help align them nicely. On the ends of the base piece, four feathers are to be pegged onto each wing.

Once installed, can be used in their extended mode to help give a more imposing stature to Nova Prime! Or can also be folded down, or in any angles as you choose.

Coming over to his alt mode, these can also be attached along his sides if you so choose.

===

So there we have it, a fun little upgrade to make Nova Prime look better and much more powerful than before! Have fun doing up this set for your own bots too and as always, happy 3d printing~! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog