Keyblade Dicesaber

"Although my heart may be weak, it’s not alone. It’s grown with each new experience. And it’s found a home with all the friends I’ve made... I don’t need a weapon. My friends are my power!” – Sora

This Keyblade-inspired dice box will insight you to wield the Power of Light and defend against the forces of Darkness. Whether fighting hordes of Heartless, evading packs of Nobodies, or guarding against the machinations of the mysterious Organization XIII, protect the hearts of the ones you care for and become a Keyblade Master! Just remember, the closer you get to the light, the greater your shadow becomes.

Overall Dimensions:

Height (Bottom of hilt to top of blade): 11.02”
Overall Dimension: 4.92" x 2.56"
Inner Chamber: 6.2" x 1.3" x 0.4"

Required hardware:
(1) M3x8mm socket head hex screw
(4) M3x18mm socket head hex screw
(2) M3x22mm socket head hex screw

Optional hardware
(6) round 8x2mm magnets
Keyring hardware

Sheath:
Lower portion of sheath has slots for round 8x2mm magnets (optional)
10% infill Gyroid
0.2mm layer height (I have had success with 0.28mm with my Prusa Mk3s)
Brim suggested, 5mm width, inner and outer.
0.40mm widths
No supports necessary
Advised to print uptight, with the flat end on the build plate

Hilt:
10% infill Gyroid
0.2mm layer height (I have had success with 0.28mm with my Prusa Mk3s)
Brim suggested, 5mm width, outer only
0.45mm widths
No supports necessary
Advised to print each piece flat on the build plate.

Dice Tray:
Lower portion of tray has a slot for a round 8x2mm magnet (optional)
Single color
10% infill Gyroid
0.2mm layer height (I have had success with 0.24mm with my Prusa Mk3s)
Brim suggested, 5mm width, outer only
0.40mm widths
Supports advised for underside (bed plate only)
Advised to print laying flat on bed

Dice Box:
Portion of tray has a slot for a round 8x2mm magnet to hold the dice tray (optional)
Single color
Slots for (2) round 8x2mm magnets to hold the sheath (optional)
10% infill Gyroid
0.2mm layer height (I have had success with 0.24mm with my Prusa Mk3s)
Brim suggested, 5mm width, outer only
0.42mm widths
No supports necessary
Advised to print upright.

Knurled grip:
Single color
10% infill Gyroid
0.2mm layer height (I have had success with 0.24mm with my Prusa Mk3s)
Brim suggested, 5mm width, outer only
0.42mm widths
No supports necessary
Advised to print upright.