Thunderbirds Sun Probe

Relive the classic space adventures with this 3D model inspired by the Sun Probe from the legendary "Thunderbirds" series. This design captures the essence of the iconic mission to the sun, blending the show's retro-futuristic aesthetics with modern detailing. Perfect for fans of Gerry Anderson's timeless creations, space enthusiasts, or those who cherish vintage sci-fi tales. Display this model on your desk, in a diorama, or as a centerpiece to ignite conversations and memories of the International Rescue's daring exploits. A tribute to one of the most memorable episodes and crafts from the series.

Material: PLA (Polylactic Acid)

Layer Height:

Standard Quality: 0.2mm
High Quality: 0.1mm
Infill:

Standard: 20%
For Increased Strength: 50%
Wall Thickness:

0.8mm (this typically means 2 walls for a 0.4mm nozzle)
Top/Bottom Thickness:

0.8mm (this typically means 4 layers for a 0.2mm layer height)
Print Speed:

Standard: 50mm/s
Detail Areas: 30mm/s
Supports:

Use if the model has overhangs greater than 45°. Depending on the model's design, you might need supports everywhere or just touching the build plate.
Build Plate Adhesion:

Type: Skirt/Brim for better adhesion and to ensure the filament is flowing correctly before the print starts.
Temperature:

Nozzle: 200°C - 220°C (Adjust based on your specific PLA brand)
Bed: 60°C - 70°C
Cooling: Enable the cooling fan after the first few layers. This helps with bridging and overhangs.

Retraction: Enable to reduce stringing. Typical settings are:

Distance: 5mm
Speed: 40mm/s