Adjustable feet ender 3 v2 and/or compatible

I made these supports to give it height and to be able to regulate them so they support better on the surface (in case the surface is not very flat), they are located in the rubber feet that brings the printer ender 3, ender 3v2 and/or compatible with them.

The idea is to give it height to better cool the motherboard, with more air intake. It also helps it not to get dirty so fast with surface dust.

They can be adjusted with the screw or, if you prefer, use it without the screw. I use it with the screw and it works perfect!

You may have trouble screwing it in the first time, you can use sandpaper or something to even out any hairs or plastic that may have been mis-attached.

Some Parameters

layer height: varies according to your nozzle (with 0,3mm use 0,24)

top and bottom coats: 2 coats work well, you can add more.

                                       for better resistance (consumes more material).

perimeter or wall: 2 lines of wall works well, can add

                                       more if you want more resistance (consumes more


                                       material).

Filling: with 15% it works perfect but you can give it

                                       more for more resistance (consumes more


                                       material).