Airsoft Multi Purpose Tripwire Spool Stake Hook For Trip Mines

Airsoft Multi Purpose Tripwire Spool Stake Hook For Trip Mines

This tripwire spool incorporates a non-metallic ground spike with hooks for attaching the end of a tripwire to various environments. The groundspike can also be jammed in or under gaps or doors in urban environments whilst the hooks can be hung on bars, grates or used to form loops with the tripwire to anchor on unusual fixings such as branches or trees if the ground is too hard for the groundspike. The notch atop the spool can help lift up the tripwire off the ground.

To fasten the tripwire, simply tie one end through one of the two holes and then the tripwire can be wound around for storage.

For airsoft use only, do not use for other tripwire uses, especially critical uses (camping bear alarms etc.) Use responsibly and safely, I'm not responsible for any injury or damage that arises from misuse. Store safely on kit to avoid injury from groundspike. A breakaway tripwire (as in a tripwire which detaches from the tripmine once pulled) is strongly recommended to avoid injury to players or damage to the mine and/or spool. NOT SUITABLE FOR CLIMBING.

I do not authorise reselling of this item, electronic or otherwise.

This is the filament I use (affiliate link): https://amzn.to/495DR9W

Printed on an Ender 3 with Esun PLA+ Olive Green filament.
Print flat on back with logo facing up
Resolution/Layer Height: Not critical, did mine on 0.32mm for speed but also printed with fuzzy skin enabled just out of curiousity.
Infill: Minimum 15% Grid. It does need to be somewhat strong.
Supports: Seemed to print fine without.
Temperatures: Will obviously vary depending on material, but printed mine with 205C nozzle and 60C bed. Printed on a Creality coated glass bed.
Bed adhesion: None required, although a skirt is always good for flushing out the hot end.
Fuzzy skin is not necessary, but wanted to try that mode out.

Copyright © Fulcrum Airsoft 2023