Final Fantasy 7 Remake: Buster Sword

Designed using Concept art from Final Fantasy 7 Remake. The Buster sword, even mostly Hollow has some decent weight to it. This is a 1/1 ratio design. When printed it is 6ft long, and just over a foot wide in the Hilt. While you CAN use it as a Cosplay piece, it is intended and recommended as an art piece for your wall. If you wish to use this file for Cosplay, you will need to widen the Dowel Slots in the Handle, and part of the blade. It should be noted that there are 5 separate "keys" that help hold each piece in place during the build. As such, make sure that each section is assembled and glued together before moving on to the next section. Print tolerances will vary, and some sanding may be required. In total, this build has 18 pieces that need printing. each of the main body pieces has a Maker's Mark stamped into them to identify which end is meant to be closest to the hilt. The Hilt pieces have the Maker's Mark stamped on the side facing the blade. This is meant to aid in the build, as some of the pieces can be confused for other sections of the Prop.

A Raft is recommended, but not required. Make sure you follow your Filament's heat settings, and your printer's speed settings when slicing the files. Infill percentage is recommended at 15%, with a minimum of 2mm Walls. As stated in the description, even thinner walls, and a lower infill percentage make this build very heavy.