[3Dino Puzzle] T-Rex Kit Card Set (Commercial License Edition)

This is a 3D puzzle set of "Tyrannosaurus" that can be made with a 3D printer. This is an upgraded version of the 3D puzzle published on my site, a kit card set model that comes with a commercially available line sense.
https://3dprintingstag-b.com/en/dino/tyrannosaurus

If you purchase this model, only the 3D printed version may be used for commercial purposes.
You may also enclose a copy of the included assembly instructions for sale at flea markets, e-commerce stores, or as a gift. Please see the License section for more details.

The following points have been upgraded compared to the free model.
・Reproduction of the cut of the skull
・Sternum and pelvis are sculpted.
・Detail of ribs, spine and tail vertebrae

[Do you want more 3Dinos?]
My account publishes 3D puzzles of dinosaurs and museums.
Check this one out too!

🦖3Dino Puzzle Series↓
https://cults3d.com/en/design-collections/STAG-B/3dino-puzzle-series-free-model

🏛3D Puzzle Museum Series↓
https://cults3d.com/en/design-collections/STAG-B/3d-puzzle-museum-set-free-model

And, STAG.B offers more than 35 different 3Dino puzzles!

🐞Please check my site↓
https://3dprintingstag-b.com/en/contents/3dinopuzzle

This model comes in four types: two without kit cards and frames, and two types adjusted to the respective qualities of High or Low-Mid.
The 20- corresponds to the kit card and the 30- corresponds to the no-frame model.
"High" is suitable for 3D printing with a Layer Height of 0.1mm and "Low-Mid" with a setting of 0.2-0.3mm.

[Print Settings]
Rafts: No
Supports: No
Infill: 20%
Nozzle: 0.4mm
Filament: PLA
Recommended company: RepRapper
Pitch(Layer height): 0.1mm - 0.3mm
Print speed: 60mm/s
Travel Speed: 100mm/s

[3D Print Time]
{Kit Card Type}
Layer Hight 0.3mm(Low): 2h16min
Layer Hight 0.2mm(Low): 2h16min
Layer Hight 0.1mm(High): 5h27min

{No Frame}
Layer Hight 0.3mm(Low): 1h52min
Layer Hight 0.2mm(High): 3h05min
Layer Hight 0.1mm(High): 4h28min