COIN HOLDER - EURO COIN DISPENSER

Simple and effective, this is my coin holder / coin dispenser design.

It has 5 slots, for 2€, 1€, 50 cents, 20 cents and 10 cents coins. Each of the areas for each coin has a front cutout so you can see how many you have inside.

Useful for delivery men and women, to pay with coins at the supermarket or simply to keep your coins organized the way you want.

The download file also includes, separately, the model of the chapitas of each type of coin where it will support the spring at the top.

For the coins to be pushed to the edge of the coin holder you have to add some compression springs. I am using 60mm high, 20mm wide and 1mm thick, although I think 70mm high would be a little tighter and better.

If you don't add the spring, you can always use it to organize your coins by simply slipping them into its recess and flipping it over to pop them out.

I have included two coin holder designs with two different finishes:

-Model with flat edges

-Smoothed / beveled edges model

If you have any questions, I'll try to give you a hand!

Print parameters with good results on an Anycubic Kobra (feel free to do your own tests):

-Layer height: 0.2m.

-Normal brackets inside the coin holder , with 0.2mm Z-spacing for easy removal as there is not too much gap and/or access to remove them.

Normal coin holders also with 0.2mm Z-spacing for the same reason as the coin holder.

-I got good adhesion on both models just by adding a skirt, but use the configuration that gives you the best guarantee of success.