Pam the Panther

This is Pam the Panther, she is a design i made some time ago, and then i made a lot of other designs and halfway forgot about her. But I looked thru my designs and found her again, so and I like her very much, so here she is! I hope you like her too :-D

I also have a Patreon, If you are interested in getting more than one file at a time. You get my full catalog when signing up, with lots of files to print:
https://www.patreon.com/Sassiecat3d

Important when buying the design:
This is my design and copyight to me sassiecat3d, it's not to be used commercially or resold without my permission, the stl file is under the same clause, not to be re-sold or use commercially without my permission. You are welcome to contact me if you would like to know more. :-) You agree to these terms when you purchace this file.

This file has my logo on the bottom since its for personal use. If you want to purchase the file without the logo, you need to get the commercial version.

For buying the commercial version where you can print and sell copys of a physical 3d printed version, go here:
https://cults3d.com/en/3d-model/art/pam-the-panther-commercial-version

I used a .4mm nozzle, .16mm layer height, I use 5% infill.

Pam prints fine down to 40%, and the keychain version makes super cute earrings in that scale :-)

No supports needed :-D It a fully print in place model!

Make sure your printer is all set with a good calibration and retraction before printing it.