3D geometry to catch drips with cork base to protect table tops.
Each coaster requires a cork base. See Amazon link below for stick-on cork coaster bases.
Holder fits 4 coasters with cork bases OR 6 coasters without bases.
Print Recommendations for Coasters
Print Material: PETG (High temperature resistance of PETG is required for this design)
Infill Percent: 8%
Infill Type: Honeycomb
Top Layers: 0 (this is required to expose the infill)
Bottom Layers: 5
Perimeters: 3
Layer Height: .15
Supports: NONE
Color Change: YES. Colors are manually swapped in the included GCODE and Prusa Slicer files. Pictured design changes to a new color for the last 4 layers.
Print Recommendations for Coaster Holder
Print Material: PETG (PLA will work just fine as well)
Infill Percent: 20%
Perimeters: 2
Layer Height: .15 (higher layer heights work as well, but layers become more visible)
Supports: NONE
Cork Bases Required for each coaster
Amazon link to pre-Cut cork bases (90mm diameter 2mm height) https://a.co/d/cpaK4Vd