LIAN LI XL SIDE PANEL SPACER (PC-O11-DYNAMIC XL) 25MM and 45MM

Includes 25mm and 45mm versions. You will need M3 screws, preferably button head, 8mm to 15mm long. Expands Left or Right sides.

Lian Li Side Panel Spacer fits the pc-o11d-rog which is the XL version of the case. If you have a regular dynamic, EVO, or a MINI model, see my other listings. Don't know what you have? Here is how to tell: The Mini is 15 inches tall. O11-Dynamic is 17.5 inches tall with front panel connections in the upper right. The EVO is 18 inches tall with the front panel connections in the bottom front. The XL is 20.2 inches tall.

Get your Lian Li case ready for those 4090 and 4080 series oversized GPUs from team green with these 3D printed spacers. Add 25mm (or 45mm) of clearance to your side panel. This should be enough for even the most giga chad AORUS 4090 (162mm thiccc) with plenty of room to spare for the power wires. Also Noctua D15 Coolers.

"High Flow" aka wide open gap side panel, helps with cooling too. (not good for keeping dust and crumbs out. Some folks have sent pictures using black non-residue tape to finish the gap and it looks decent.)

DO NOT MOVE YOUR PC / CASE with side panel on after installing these spacers. The top panel no longer locks in the side panel. If you tip the case too far your glass side panel is very likely to slide off and shatter.

On the XL model there is a slight difference on the bottom spacer tab geometry and only one pair of upper spacers. The side panels of the XL do not have any middle hanger nubs.

Full List of compatible cases (to my knowledge)
O11DXL-X, O11DXL-W, O11DXL-A

Highly refined design for 3D printing without supports.
File Includes both versions in one STL, only print one row.

I recommend any material better than PLA. Air temps in a power hungry case can be hot enough to soften PLA. ABS comes out great in a Bambu enclosed printer.

0.20-0.24mm layers, 3 walls, 25%infill, 6top/bottom layers.