G1 Onslaught Double Barrel Missile Launcher

A replacement double barrel missile launcher accessory for G1 Onslaught or any of the repaints of the mold. The pegs for this model that attach to onslaught may require light sanding for a snug fit.

This is model is comprised of 4 separate STLs, and the final model is capable of the same range of movement as the original.

Assembly using glue will be required to assemble the full model

Assembly Instructions
1. Slide part B under the rail on part A. In order to fit part B through you’ll need to angle part B at around 45 degrees to part B. There is very little between the parts, so it will require some light force to fit the pieces together.
2. Once part B is inserted, carefully glue part C to part B at the two tab between the two. Avoid gluing part A, this should slide freely between part B & C.
3. Optionally glue part D in place. Part D should stay in place with friction if desired.

Not what you’re looking for? See my G1 Bruticus Collection for other G1 Bruticus parts, or my G1 Collection for other accessories from other figures.

Printed successfully on an Ender 3 v2, 0.08mm layer height, 190 degree hotend. Supports required.

I recommend printing parts A,B, and C in the current orientation. I recommend printing part D with the barrels point straight up.