AR stanag or pmag magazine tactical pouch for military airsoft

Original format: Solidworks 2022, 3DS max (only MOLLE straps)
Per one mag you will need to print:

• front_part x1
• back_part x1
• side_part x2
• bottom_part x1
• pouch_lock x1 (optional)
• molle_strap x1 (includes two straps) + 3 mm round cord - 88mm for pouch 3 mm round rubber cord

Developed for AR and AK Mags.
Filament: Elastan D100 for the pouch itself; softer TPU for the MOLLE straps. 100% fill, ironing for best look. You can try other materials.
A round rubber cord diameter up to 3 mm.
For the pouch itself you will need 880 mm for the pouch itself and 38 mm for the pouch locking cord.

You can use other materials and test it on your own.

AK mags sit very tight. No need for mag lock part (retention) even if you cary it upside down (to get the mag from the back of your plate carrier).

AR mags sit just perfectly. Mag retention might be needed for some mags models to carry the pouch upside down. Also depends on material.

If you are using any other type of mags:
mp5 mags sit too loose
UMP45 mags sit OK, but not perfectly
AK 47 mags sit good
AK 74 mags sit Good
Pistol mags mostly sit too loose
G3 mags sit very tight.

These mag pouches had a lot of history and iterations since 2022. This model is real war and modern warfare prooved.

Cura
100% infil
2 walls /2tops/ 2 bottoms
+ Ironing for best look
Material: pouch body: Elastan D100
MOLLE straps: TPU