Princess mermaid necklace - Mermaid Melody

This is the necklace that contains the pearl of the mermaid princesses from Mermaid Melody.

The mecklace is about 65 mm long ( close ) and is split into two parts to fit an Ender 3.

It has a 2 holes of 4mm. One to place a small 4mm stick to open and close the necklace and another to hole the thread so it can be placed around the neck.

For a PLA printer advice these settings:

Quality: Lower possible
Walls: 3 or 4
Infill: 10%
Pattern: Zig Zag

Unfortunately I don't have a resin printer, so I don't know what would be the best settings for this printer.

• Will need some small supports

• The top part i advise you to put around 4 walls so that will have minimum minimum infill possible. Personally I would put 6 or 7 pardes, but the initial suggestion is also a good option.

• The bottom, it is possible to use a higher resolution (2.8 mm) and 2 or 3 walls with 10% filling. But the details around the pearl will not be as well defined compared to a high resolution.

• I recently discovered a new feature in the program I use, so all parts were exported in high definition.

If you liked the model, please click on like and rate. It is very important for me to know that they like my models. If you have any suggestion or doubt, do not hesitate to ask. :)
You can whenever you need to send me a message here (Cult3D) or on my Instagram. @Titi_Cosplay