Santa Claus on vacation - DO NOT SUPPORT

This Christmas prototype of Santa Claus clacs is a 3D STL printing model, WHICH DOES NOT REQUIRE ASSEMBLY OR SUPPORTS AND PRINT VERY WELL IN PLA, you will find it in 2 legs body and legs which have a system of articulated pins, which can be placed with pressure, these legs have a rotation axis that helps to put the legs in any posture....

you will also find a full body Santa Claus, to print, without supports and one with a hole for hanging.

Santa Claus Claquea for parties, a christmas and decorative model for this season

You will find 3 files of Santa Clacs, 2 bodies, one of them of high quality, as it is a very detailed model and another of low quality, also the right and left legs.

You will find Santa Claus with a hole in the hat, maybe you can hang it on the Christmas tree.

*THE LEGS SHOULD GO STRAIGHT INTO THE PIN, WITH A STRAIGHT PRESSURE, TO AVOID TUCTURE, ALREADY INSIDE THE LEG YOU CAN ROTATE THEM IN DIFFERENT WAYS.

I will leave a link to my disk, who wants the STL files.

As with all my 3D models, I made several iterations to make sure it was sturdy and easy to print without supports.

Feel free to share images of your prints on this page, I'd love to see them.

If you like my flexible Santas, check out my other models you'll love them.

For all users who have an active subscription to my https://www.patreon.com/studiosDB92 you will find an authorization letter from STUDIOS DIGITAL BROTHESR to be able to sell all the models already 3D printed.

ALL STUDIOS DIGITAL BROHESR designs are protected by copyright law. My digital files may NEVER be resold or shared in any way.

Subscriptions promo stl models at: https://www.patreon.com/studiosDB92

3D PRINTING PARAMETERS

*Not supported

*In-situ printing (without mounting)

*15¿ to 20% fill to be sure.

*I suggest 3 walls to make the peaks stronger.

*PLA works very well

*Make sure you have good adhesion on the bed if you are going to print small size use a balsa.

Thank you..................

3D PRINTING PARAMETERS

*Not supported

*In-situ printing (without mounting)

*15¿ to 20% fill to be sure.

*I suggest 3 walls to make the peaks stronger.

*PLA works very well

*Make sure you have good adhesion on the bed if you are going to print small size use a balsa.

Thank you..................