"Furl" Lampshade in 3 sizes

The 'Furl' Lampshade is an addition to the Furl Vase collection, resembling the aesthetic of wrinkled cloth, but for a collection of lampshades. The Furls are slightly weaker than for the vases, ensuring that an E14 light bulb fits easily into the lampshade.

On the top side, there is a 30mm wide hole for an E14 lamp socket that can be secured with two screw rings.

Please note that the light only shines out from the lower side of the lampshade. Keep this in mind for the interior where you may consider using these lampshades, or use a transparent filament. :)

This collection contains 3 vases in 3 different sizes, which are listed in the 3D printing settings.

If you encounter any problems with this file after purchase, please contact me and I will update it!

No support structures are necessary (I didn't use any, but feel free to use them if the print fails without them for some reason).
I used Cura Slicer with 100% infill and printed with wood-PLA filament at a layer height of 0.3 mm.

The total print weight is approximately:

Small: 90 grams
Medium: 124 grams
Large: 136 grams
I printed the models on my Ender 3 Pro using files I sliced in Cura Slicer 5.2.1.

Print speed (approximately at 65 mm/s):

Small: 5h 50min
Medium: 7h 50min
Large: 8h 35min
Print Sizes:

Small: x: 100.55 mm, y: 98.98 mm, z: 149.1 mm
Medium: x: 99.68 mm, y: 103.57 mm, z: 198.76 mm
Large: x: 101.85 mm, y: 98.10 mm, z: 223.93 mm