Button block for the Eggbot, Spherobot, Eggduino etc.

Button housing for manual control of functions on the Eggbot:

• Pause printing, e.g. to change pens etc.

can then be restarted in the Inkscape Eggbot extension or canceled with Homing.

• Raise or lower the pen,

this no longer needs to be controlled in Inkscape....

• Activate/deactivate motors

is intended, unfortunately it doesn't work for me, maybe someone else has an idea ;-)

Addendum 06/22: Error found, there is a bridge ( EN/GND ) on the circuit board directly under the reset button,

must be removed, then the motors can be deactivated.

The pin assignment can be seen in the pictures,

A 31x20 mm breadboard and the three buttons are required,

e.g.6x6 mm tactile pushbutton switch 4-pole pushbutton switch

Button support must be activated in the software for the Arduino,

otherwise it will not work.

Key housing for manually controlling functions on the Eggbot:

• Pause printing, e.g. to change pens etc.

can then be started again in the Inkscape Eggbot extension or aborted with homing.

• raise or lower pen,

You don't have to control it in Inkscape anymore...

• Activate/deactivate motors

it's intended that way, unfortunately it doesn't work for me, maybe someone else has an idea ;-)

Addendum 06/22: Error found, there is a bridge (EN/GND) on the circuit board directly under the reset button,

that has to go, then the motors can be deactivated.

Connection assignment can be seen in the pictures,

a breadboard 31x20 mm is required and the three buttons,

e.g.6x6 mm tactile pushbutton switches 4-pin pushbutton switch

Button support must be enabled in the software for the Arduino,

otherwise it doesn't work.