Yellow Modern Snowcat / Snow Groomer with Movements

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:6317605.

A snowcat/snow groomer is a large vehicle mainly used to pack snow and improve conditions for skiing, snowboarding, and snowmobile trails. Apart from these functions, it can also be modified to fit exploration and other niches

I am very thankful to (Mr Benoît Lussier)[https://www.printables.com/@BenoitLussier] for his feedbacks which has helped me refine the model further. (Please Click Here to check out his make)[https://www.printables.com/model/649176-yellow-modern-snowcat-snow-groomer-with-movements/comments/1293326]

##There are three ways to print this.

1. As single piece:- Please download STL file but there wont be any movements.

2. Multiple Pieces :- Download 3mf fie with Full_dismantled.3mf.** BEST QUALITY OUTPUT**. Please use the 3mf file for assembly also.

3. Combined:- You may use any 3D viewer software like 3D builder in windows to merge components according to your printer and filaments. The sky is the limit for this. You may find a sample file ending with combined.3mf.

#<ins>EASE OF PRINTING

1. This model contains parts of 5 colours - GREY, RED, YELLOW, BLACK & WHITE. I have seperated these into different plates according to colour and in the optimum print position. Please download the file "Print Plates According to Colour.zip" and extract to make use of them. There are total 12 plates with what colour to print in mentioned with the name. These plates can be opened in any slicer and printed according to your print profiles.
2. For those who use orca slicer. Please download the file “Orca Slicer Full Dismantled Snowcat.3mf” for use in Orca slicer. I have already added object specific print setting to parts but please make sure the setting are correctly applied post slicing.

<ins> If you want to try TPU for tracks, you can download the "Snowcat_TPU_track.3mf" but please note that I haven't tested them.

#<INS>ASSEMBLY OF MODEL

##<ins>PART-1 ASSEMBLY OF MAIN CAB

##<ins>PART-2 ASSEMBLY OF UNDERCARRIAGE

##<ins>PART-3 ASSEMBLY OF FRONT BUCKET

##<ins>PART-4 ASSEMBLY OF REAR GROOMER

##<ins>PART-5 ASSEMBLY OF WINCH The beam of the winch has a 2.25mm diameter path cut through it to route the rope to operate the winge. Here you have two options. either use a rope with max diameter of 2mm or a 1.75mm 3D printing filament. If you choose the first case you can tie the rope to the hook and route the rope through the beam and then through the rotating platform can reach the winding drum. In this case you can skip the winding spool design over the drum and use the hole on the drum to tie the rope and wind. If you choose to use a filament, it would be a make belief thing and thus no need to route it past the rotating plate. See the image for reference. The yellow part is the rope/filament.

##<ins>PART-6 MATING OF ALL PARTS

#<ins>Movements Included

1. Front Bucket Movments
2. Rear Groomer swing and lift
3. Crane Operations
4. Track movement (only with TPU - Untested)

NOTE <ins>The tolerances to some elements are zero which has been intensionally provided to friction lock the elements while not in movements. You may have to fine tune the tolerance from your end using scaling funtion in slicer to ensure good fit without compromising movements.This also applies for the pins that make rotation possible between elements. Please proceed with printing all the pins after testing printing a pin and testing the fit of a joint. You should be able to find the adequate scaling factor with this.</ins>

Supports should be provided as required.

Appreciate the makes uploads.Open for suggestions.