simpel PET machine from Ender 3 pro

I made a simpel pet machine from an old ender 3 pro, so that even people who have little to no knowhow when it comes to electricity can make one fast and easy. It is also made with as few parts to print as i could manage, so the whole thing can be printet on 2 plates if need be.

I've tried to take as many photos of the process to make it as easy as passible, i might make a video if need be.

The parts needed from the ender is:
The motherboard
a steppermotor (i used the extruder motor and port but i assume every motor and port can be used)
the whole hotend, with heater, censor and the plate it sits on
the screen
the power source
a Wheel and spacer
(optional) the cooling fan
and a few other screws and bolts

I shortened the heater wire (the easiest to shorten), and if you dare you can shorten more wires but I've made space enough for the wires as is, i did swab the wire to the steppermotor to the shortest one on the ender.

i made the machine in a way so you will have to dismantle as little as passible when making it. There is a small tap where the on/off wires go that should be clipped, it is there to make it easier to print without support.

it uses normal filament spools so they can also be reused
I've made 2 files where all is collected so it is easy to print but also one for every individual part

i suggest 0.28 mm resolution
can be printed without support (but might benefit from supports if you want the roof of the inside crispy clean)