Lethal Company Wearable Helmet

#Lethal Company: Wearable Helmet for Cosplay or Display

Note: This is a WIP. The 3D models may be updated in the future, so please only print if you are confident that you can make this work for yourself.

The Company has requisitioned a replacement helmet for your scavenging needs - remove any remains of the previous employee before wearing.

The ear and mouth pieces can be printed separately to minimise the use of supports. Additionally, they can be connected to the helmet base via slots (be sure to use some super glue to seal it tight)! Lastly, holes have been included in both pieces to allow you to hear and communicate to your fellow employees.

It is not recommended that you print the visor with an FDM printer. If you wish to print it, using a transparent resin in an SLA printer may yield better results. The company has provided a visor mould that can be printed on FDM printers should you wish to heat a thin sheet of clear plastic and press it against the mould. It is recommended that you leave a little excess around the edges so that you can stick it onto the inside of the helmet.

Please scale the helmet according to your head size. You may want to add some thick pieces of foam for comfort whilst you search for scrap in the facility.

#Important: The opening for the helmet is quite narrow (as per the design from the game), so you may also wish to scale up more than you think is enough - or split the helmet into two.