Earth organizers

Organizers for Earth board game. Quick game set up and comfort during the play. Sliding lids prevent components from falling out during the storage. Theme reliefs decorate lids.

The set contains: Resources organizer, Card organizer, Earth card tray and Player's component organizer.
1. RESOURCES ORGANIZER: All types of resources are accommodated here in separate sections. Rounded bottom facilitate item draw. I keep Canopies by color, but you can, of course, mix them. One Resources organizer is dedicated for a half of resources tokens. Thus 2 of such organizers should be 3d printed. I keep them on 2 sides of the table, so all players can reach for components easily during the play. The container is 220 mm long.
2. CARD ORGANIZER: All short decks are kept here. They are accommodated in separate sections adjusted to the deck's thickness. The symbols on both side walls indicate which cards go where. Sloped back and section walls + indentations facilitate taking decks out. It is designed for cards without sleeves.
3. EARTH CARD TRAY: The deck of Earth cards is so thick that I have divided it in 4 piles. Each one is kept in the Earth card tray. You can shuffle all cards before the play and then put them in trays that can be kept near players. Sloped bottom and indentation facilitate the draw.4 trays fit the game box next to other organizers. The 5th won't make it.
Trays were designed for cards without sleeves, but I made them a bit larger, so sleeved card probably will fit it too.
4. PLAYER'S COMPONENT ORGANIZER: The central section in the organizer is dedicated for a pile of 5 Leaf token trays. Trays can be easily taken out thanks to indentation in the side wall of the organizer. There are also 2 pockets where First and Active player tokens are kept.

All organizers fit the game box very well and provide quick game setup. However it's not an insert. Comfort during the play is always the priority in my designs. Theme reliefs highlight the game atmosphere.

Some photos in higher resolution:
The set, sliding lids prevent components from falling out
The set, organizers open
The set, organizers closed
Resources organizer
Card organizer
Packed
Half unpacked
Game set up for 4 players

All organizers were 3Dprinted on Prusa MK4 (with InputShaper):
- in PLA (F3D Gold pearl),
- No support is needed,
- Infill 10% gyroid.
Note1: I use slightly changed default Print settings "0.15mm SPEED MK4" in PrusaSlicer.
Note2: Monotonic top/bottom fill as default.
Note3: Resources organizer is large, its size is: 164 x 220 x 29 mm.

Printing Time (for one organizer of each kind) (with InputShaper):
5h15' - Resources organizer, container
2h39' - Resources organizer, lid
4h36' - Card organizer, container
54' - Card organizer, lid
1h30' - Earth card tray, container
30' - Earth card tray, lid
1h24' - Player's component organizer, container
25' - Player's component organizer, lid
15' - Leaf token tray