Coffee Cup Prank Set

Do you want to have fun and prank your friends?
Try the prank - Upside down cup of coffee.
The set contains all the necessary STL files for 3D printing: Cup, Saucer, Coffee Foam, Rings for holding the thread on the finger and securing the thread in the cup.
Additionally, you have to have fishing line or thin white thread approximately 25cm long.
Since the thickness of everyone’s fingers is different, the project provides rings with different diameters: 20, 25, 30mm.
For the Cup, Saucer, Rings I used plastic - Sunlu Silk PLA+ White, for the Coffee Foam - Sunlu Silk PLA+ Red Copper. But you can use any other similar plastic.
How to assemble the set:
- Secure the fishing line to one Ring using knots.
- Pass the other end of the fishing line through the bottom of the Saucer and Cup into the holes that are in the middle.
- Also secure the other end of fishing line to the Ring using knots.
- Insert the overlay Coffee Foam into the cup from the top.
- If necessary, you can remove the Coffee Foam using a pen by inserting it into one of the lower holes in the cup and thus pushing out the overlay.
Please remember all people are different, some can't understand your joke and be offended. Please be tactful and respect others!

• Layer – 0.2
• Filling – more than 20%
• Supports – no