Lorenzo il Magnifico organizers

Organizers for Lorenzo il Magnifico base board game. They provide quick game set up and comfort during the play. Sliding lids prevent components from falling out during the storage. Lids are decorated with theme reliefs and cutouts.

The set contains: Resources organizer, TileDiceCard organizer, Card tray and Player's component organizer.
1.RESOURCES ORGANIZER: All types of resources are accommodated here in separate sections. Rounded bottom facilitates component draw.
2. TILEDICECARD ORGANIZER: Different components that are used in the game set up are organized here in well adjusted sections: Personal bonus tiles, Excommunication tiles, Covering tiles, 3 dice and Leader cards.
3. CARD TRAY: This tray enables organizing Development cards by color and period. 3 of such trays should be 3d printed to accommodate all decks. There are 3 lids, each one is dedicated for one period: I, II and III. The tray has sloped bottom and indentations to facilitate the draw. During the play, after each Vatican Report, the next tray is taken.
4. PLAYER'S COMPONENT ORGANIZER: There is a small organizer for all components of one player. 4 of them can be comfortably accommodated inside the large players' organizer. The small organizer has 4 slots for 4 Family Members (cylinders) - using it during the play is such a comfort. There is also a tray for discs and cubes. A simple plug-in lid is used to cover this section during the storage. Sliding lid dedicated for the large players' organizer prevent cylinders from falling out while the game is stored.

All organizers fit the game box very well and provide quick game setup. Theme reliefs and cutouts correspond with the drawings on the game box. I have enjoyed designing them very much :)

Some photos in higher resolution:
The set, organizers closed
The set, organizers open
Game set up for 4 players
Packed
Half unpacked
Almost unpacked

Organizers were adjusted for cards without sleeves, but I've made larger spaces, so sleeved cards should fit there too. (Though, as I don't have cards in sleeves, I can't guarantee it.)

All organizers were 3Dprinted on Prusa MK4 (with InputShaper):
- in PLA (F3D Gold pearl),
- No support is needed,
- Infill 10-15% gyroid.
Note1: I use slightly changed default Print settings "0.15mm SPEED MK4" in PrusaSlicer.
Note2: Monotonic top fill as default.
Note3: The largest container is Resources organizer. It's dimensions are: 200 x 140 x 21 mm.

Printing Time (for one organizer of each kind) (with InputShaper):
- 3h36' - Resources, container
- 3h24' - Resources, lid
- 3h52' - TileDiceCard, container
- 3h - TileDiceCard, lid
- 2h22' - Cards, container
- ~1h42' - Cards, lid
- 3h22' - Players, large container
- 2h20' - Players, large lid
- 50' - Players, small container
- 6' - Players, small lid