BrittLiv, 123d Pythagorean Cup

BrittLiv said she would make this in 3d if she could so I made a design for her, and if you like this look at my ukulele or soap mold box too so, lets get started. If you want info on what this is look it up on Brittliv's instructable.

I made a cup and than another bigger one, I connected them together to make a cup in a cup.

Next I used two Long rods to make a tunnel for the water flow.

I made a small opening in the cup at the bottom as an "entrance" to the tunnel.

I made a hole near the top of the tunnel to show how high the water level would be to "escape"

Next I made another bigger cup to put our previous one in

Ok so now I built an area to control where the water falls and a square exit for the water to escape.

So the last part is to put on a lid. I put on a top to cover the whole thing and than slowly cut away until I hit the edge. After that you are done!!

I chose silver or a shiny color to make the cup look cool. Now you're done!