Tablet car support

Tablet holder to hold the tablet, so that children and adults are entertained during car trips.

Attaches to the back of the front seat headrest bars.

Easy to mount and dismount.

Easy to attach the tablet.

I currently have two placed in the car and am delighted. My kids are entertained on trips.

This support is valid for many types of materials. PLA, ABS, PETG, etc. The better the material, the better the quality and strength.

The unit in the photos is made in Colorfabb XT-CF20.

0.4" nozzle

Layer height 0,2

Filling percentage 50%

Solid bottom layer 5

Solid top layer 5

Contour/perimeter covers 7

Bedding temperature 65

Extruder temperature 240º

Speed 70 mm/s

Without layer fan

There is only one part that needs support "Claw support". The rest is designed not to need support.

The following materials are required for assembly;

• 2 x 5 x 30mm screws with exagonal head. For the clamps for attachment to the headrest bars.

• 1 x 5 x 65mm hex head screw. For tightening the inside of the swivel joint.

• 2 x 5 x 10mm allen countersunk head screws. To fasten the swivel part to the main tablet bracket.

• 1 4 x 35mm countersunk allen head screw. This screw acts as the spindle for the height adjustment brake.

• 5 x 5mm nuts

The nuts are housed in the hexagonal recesses of some parts.

It is recommended to glue some rubber sheets or eva rubber, so that the device has a better hold.

Valid for printing on any printer 200 x 200 or larger.

It is recommended to sand and round off any edges or burrs that may remain. They could cause injury or cuts.

If you use longer screws, they should be cut to length so that they do not protrude. As well as rounding the ends and removing any burrs.

The creator is not responsible for any damage caused by this device.