"Ulti" hybrid gold wash trough/highbanker // "Ulti" hybrid slice banker

The "Ulti" hybrid gold panning chute is the ultimate solution for every gold panner who wants to have both a gold panning chute and a highbanker with them when searching for gold.

The "Ulti" hybrid gold panning chute can be easily folded down and converted into a highbanker.

The gold wash trough uses 4 Miners Moss mats for the washing process.

Also used are 4 different expanded metal meshes and a few individual riffles between the systems.

You can also easily attach 4 support legs.

The 4 legs can also be easily attached to the holder for transportation, making them easy to stow away.

The hose connection can also be easily screwed on and off.

Depending on the quality of your printer and its accuracy, you may need to adjust the width of the expanded metal so that it fits properly at the end.

The following items are also required:

27 M6 x 20mm screws

2 screws M6 x 30mm

29 M6 washers

29 M6 nuts

(An M6 wing nut can also be used in the center for easier removal of the base plate)

You will also need 4 Miners Moss mats with the following dimensions:

A: 154mm L x 128mm W x 10mm H

B: 96mm L x 138mm W x 10mm H

C: 129mm L x 144mm W x 10mm H

D: 132mmL x 151mm W x 10mm H

And a water hose with a diameter of 4 cm and a hose clamp are required for operation as a highbanker (and of course a suitable water pump).

The "Ulti" hybrid gold panning trough is the ultimate solution for every gold panning trough who wants to have both a gold panning trough and a high banker with them when searching for gold.

The "Ulti" Hybrig gold panning trough can be easily folded down and converted into a high banker.

The gold washing trough uses 4 Miners Moss mats for the washing process.

Four different expanded meshes are also used and a few individual corrugations between the systems.

You can also easily attach 4 legs.

The 4 legs can also be easily attached to the holder for transport and are therefore easy to store.

In addition, the hose connection can be easily screwed on and off.

Depending on the quality of your printer and its accuracy, you may have to adjust the width of the expanded mesh so that it sits properly in the end.

In addition, the following things are required:

27 screws M6 x 20mm

2 screws M6 x 30mm

29 M6 washers

29 M6 nuts

(An M6 wing nut can also be used in the middle to make it easier to remove the base plate)

4 Miners Moss mats with the following dimensions are also required:

A: 154mm L x 128mm W x 10mm H

W: 96mm L x 138mm W x 10mm H

C: 129mm L x 144mm W x 10mm H

D: 132mmL x 151mm W x 10mm H

And a water hose with a diameter of 4cm (1 1/2 inch) and a hose clamp are required for operation as a high banker (and of course a suitable water pump).

0.3mm layer height // Support // PETG Recommended